| Yamaha
XTX 660
STAINTUNE FUEL INJECTION CONTROL UNIT INSTALATION
After following the standard fitting instruction of the unit, these
are the “pot” settings applicable.
YAMAHA XTX 660 SFi
Unit 1025
Settings for bike fitted with standard system
Display guide:
Green: Idle Yellow: Acceleration
Red: Cruising RPM: No led indicator
Injector Wires: Connect each of the SFi Unit wires which are Blue and
Grey to the injector wires. It is not important which way they connect,
as they will operate either way.
Connect the power wire RED to the tail light wire, this will ensure
the unit is activated only when the ignition is on and therefore won’t
run the battery down.
Connect the earth wire BLACK to a clean earth spot.
Important: If you have had an FIM download already installed into your
ECU, the SFi will not provide you with satisfactory results. The
SFi units have been designed to work from the standard ECU configuration.
It won’t be uncommon to have the red fuel pot higher than the base settings
with a Staintune exhaust system fitted.
This information available in MS Word format:
Yamaha XTX 660.doc
See also: General SFI Fitting Instructions |
