| SUZUKI
DL 1000
STAINTUNE FUEL INJECTION CONTROL UNIT INSTALLATION
After following the standard fitting instruction of
the unit, these are the “pot” settings applicable.
SUZUKI DL 1000
SFi Unit 1025
Display guide:
Green: Idle - Position 3 Yellow:
Acceleration
- Position 3 Red: Cruising - Position 2
RPM: No led indicator – Position 5.5
Injector Wires: Connect each of the SFi Unit wires which are Blue
and Grey to any one of the of the injector wires.
Connect the power wire RED to the tail light wire, this will ensure
the unit is activated only when the ignition is on and therefore won’t
run the battery down.
Connect the earth wire BLACK to a clean earth spot.
Important: If you have had an FIM download already installed
into your ECU, the SFi will not provide you with satisfactory results.
The SFi units have been designed to work from the standard ECU configuration.
It won’t be uncommon to have the red fuel pot higher then the
base settings with a Staintune exhaust system fitted.
This information available in MS Word format:
Suzuki DL 1000.doc
See also: General SFI Fitting Instructions |
